Tikkurila Oyj
PRODUCT DATA SHEET
05.09.2005
 

Road marking paint, water-borne

Description
Extremely fast drying water-borne road marking paint formulated with a special acrylic resin.
Product features
For marking traffic lines on asphalt and bitumen etc. surfaces.
Recommended uses
Roads, streets and parking areas.

TECHNICAL DATA
The paint is full-matt The paint is water-borne Tool: roller Tool: spray Tool: brush
The coverage of the paint on rough surfaces
1
m2/l
The coverage of the paint on smooth surfaces
2
m2/l
Colour Range
White, yellow
Gloss grade
Full-matt
Coverage
About 1-2 m2/l, depending on porosity of the surface
Can sizes
1 l, 10 l.
Thinner
Water
Application method
Spray, brush or roller
Drying time at 23°C and 50% relative air humidity
Drying time depends on relative humidity of the air, the temperature of the air, air flow and thinning of paint.
Weather resistance
Good
Wear resistance
Good
Solids volume
About 62 %
Density
About 1.7 kg/l, ISO 2811
Storage
Protect from frost

APPLICATION DETAILS
Application conditions
The surface to be painted must be dry, the temperature of the air, paint and surface during application should be at least +5°C, and the relative humidity of the air below 80 %. The surface must not be more than 3°C colder than the air. Do not use the paint when rain is expected.
Preparation
Remove sand and other loose particles as well as oil and grease from the surface.
Painting
Stir well before use. Paint dries extremely fast, but it is possible to make the drying time longer by adding water up to 5 %. Apply by brush, roller or spray. For spray application, spray a thin layer of water on the surface of the paint to prevent a thin layer of dried paint from forming on top of the open container. If you are storing an opened can, spray water on the top of the paint and close the lid well.
Cleaning of tools
Clean tools with water. Tikkurila Pensselipesu (Brush Cleaner) is recommended to be used to remove a bit harden paint.

If the sprayer has been used to apply paint requiring thinner, the equipments must be cleaned with appropriate thinner very carefully. A large quantity of water must then be used to rinse out the thinner from the sprayer. Pay special attention to the cleaning of the sprayer filters.
Maintenance instructions
Dirty surface can be cleaned on the following day with water, without detergent.

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
Not classified as hazardous for health. Handle with care. Avoid prolonged contact with skin and breathing of spray mist. A Safety Data Sheet is available at request.
Käyttöturvallisuustiedote

ENVIRONMENTAL and WASTE DISPOSAL
Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations for hazardous waste.
TRANSPORT
VAK/ADR -
SNA241095 / ENI241095 / inh051005 / mpy050905 / 006 6900, -6901