The Temafloor 6 system is recommended for areas where a non-slip finish resistant to UV light, abrasion, pressure and salts is required.
Typical applications include footbridges, bridges for vehicles, ramps and underground parking spaces.
Temafloor 6 is prepared by adding sand to the Temafloor PU polyurethane coating. The coating is topcoated with Temafloor PU-UV polyurethane coating.
Priming is carried out with Temafloor 400 according to the instructions of the product data sheet. A layer of Temafloor PU polyurethane screed, up to a thickness of 2 mm, is applied to the surface, following the instructions given in the data sheet. While the screed is still wet, sand with particle sizes of 0.6 to 1.2 mm is scattered over it, until the entire surface area is thoroughly covered. Excess dry sand is removed on the following day. The dried coating is given a topcoat of Temafloor PU-UV polyurethane coating.
|For Interior or Exterior Use||Interior, Exterior|
|Surface||Metal, Concrete, Floor|
|Product Category||Topcoat, Screed, Other|
|Sheen Level||Semi Matt (11-35%)|
|VOC Levels||Ultra Low (5-49 g/l)|
|Theoretical Cover Rate||See system sheet|
|Touch Dry||See system sheet|
|Waterbased or Solventbased||Solvent|
|Recoat Time||See system sheet|
|Single Pack or 2 pack||3 Pack|
|Product Solutions||Concrete Bridges, Concrete floors - Car parks and aeroplane hangars, Farming & Agriculture facilities - concrete, Harbour Infrastructure, Repair and Maintenance|